Introducing Tensor Bullet Bond Mist Spray – the perfect adhesive solution for effortlessly affixing sandpaper sheets to foam pads. Simply spray and adhere. For a temporary bond, lightly coat the sanding pad with the adhesive. With this innovative spray-on formula, you can apply and remove sandpaper multiple times without any hassle.
Tensor Bullet Bond Mist Spray isn't just limited to sandpaper – it's also great for applying carbon to foam blanks. Tensor Bullet Bond Mist offers a precise mist spray adhesive that securely holds fibreglass, carbon tape, or Fused tapes in place without seeping into them. Ideal for tasks like laying tail/hit patches and carbon/reinforcement centre strips, it ensures a firm grip while you work.
Instructions for Using Bullet Bond Spray Adhesive with Sandpaper:
-
Prepare Your Work Area:
- Choose a well-ventilated area to work in. Consider using a drop cloth or newspaper to protect the surrounding surfaces from overspray.
-
Prepare the Surfaces:
- Ensure that both the surface you're applying the sandpaper to and the back of the sandpaper are clean and free from dust, dirt, or any other contaminants that could affect adhesion.
-
Shake the Can:
- Shake the can of Bullet Spray Adhesive vigorously for about 30 seconds before each use. This ensures proper mixing of the adhesive components.
-
Spray Application:
- Hold the can of Bullet Spray Spray Adhesive upright approximately 6 to 8 inches away from the surface you're spraying.
- Apply a light, even coat of adhesive to the back of the sandpaper. Avoid oversaturating the surface, as this can lead to excessive adhesive buildup and potential issues with adhesion.
-
Allow for Tackiness:
- Let the adhesive tack up for a moment after spraying. This usually takes around 15 to 30 seconds, depending on environmental conditions such as temperature and humidity. The adhesive should feel slightly sticky to the touch.
-
Apply the Sandpaper:
- Carefully position the sandpaper onto the desired surface, ensuring proper alignment.
- Press firmly on the surface of the sandpaper to ensure good contact between the adhesive and the substrate. Applying even pressure helps to eliminate air bubbles and ensures a strong bond.
-
Allow for Cure Time:
- Allow the adhesive to fully cure according to the manufacturer's recommendations. This typically takes anywhere from 15 minutes to 1 hour, depending on environmental conditions and the materials being bonded.
-
Cleanup:
- If any overspray or adhesive residue gets onto unintended surfaces, clean it up immediately with a solvent recommended by the adhesive manufacturer. Follow all safety precautions and disposal instructions provided with the solvent.
-
Safety Precautions:
- Always wear appropriate personal protective equipment (PPE), such as gloves and a respirator, when using spray adhesives to avoid inhalation and skin contact.
- Keep the work area well-ventilated to minimize exposure to fumes.
-
Storage:
- After use, store the can of Bullet Spray Adhesive in a cool, dry place away from direct sunlight and sources of heat. Ensure the cap is securely tightened to prevent evaporation of the adhesive.
-
Note:
- Follow all safety instructions and recommendations provided by Tensor Grip on the can for the safe and effective use of their products.
