XPT227 FlexNet: 25" (Aramid 1/2" Diamond)

(Inc. GST)
(Ex. GST)
(No reviews yet) Write a Review
Calculated at Checkout

Width: 635mm | 25”
Colour: Black/Clear
Diamond Pattern: 1/2" Spacing

FlexNet Tape

The FlexNet Series uses Aramid (also know as Kevlar), due to it incredible tensile strength and offers a more lively flex to carbon as Kevlar does not get stiff but offers high impact strength when laminated. We have manufactured the FlexNet in an X pattern, this is because once it has been applied to the board it allows the board to have multiple flex outlets. The X Pattern spreads to flex to the tail, rail any other part of the board when in use. The FlexNet is our lightest rail tape, patch and cloth. 

Industry Uses:

Back Rails Manufactures place the FlexNet Tapes on the back rail of surfboards to prevent the tails from shattering and strengthening the deck from foot compressions.

Bottom of the board The FlexNet Tapes are also used on the bottom of the surfboards to create additional spring or pop out of the board. This is know as a kinetic flex, as the board is place under pressure while in transition, during or out of a turn the board springs back to its natural curvature and delivers additional speed.

Full Rail of the board The FlexNet Tapes are often used along the full length of the surfboard rail with stringerless surfboards. This is to add additional strength or to replace the strength that a timber stringer would provide, therefore creating a Parabolic Frame. The Parabolic Frame helps prevents the board from twisting which increases the liveliness/responsiveness, this also creates a parabolic flex pattern that allows to board to deliver more drive, speed and power.

Lay-ups: The FlexNet Tapes are used during the lamination process. The tapes are place on the foam before the cloth is laminated. Most manufactures mark the area they wish to place the FlexNet, and brush a small amount of resin on the foam (to prevent to the FlexNet Tapes from moving). The FlexNet Tapes are then placed on the resin (making sure the resin has soaked through) and then continue to lay the cloth over the board and laminate as normal. 

Resin Compatibility: 

The FlexNet cloth is compatible with both Epoxy and Polyester Resin.